ARTRA Fire Protection CM90 Teknik Veriler - Sayfa 5

Duman Alarmı ARTRA Fire Protection CM90 için çevrimiçi göz atın veya pdf Teknik Veriler indirin. ARTRA Fire Protection CM90 5 sayfaları. Wireless smoke detector

ARTRA Fire Protection, email : [email protected]
ARTRA Fire Protection, email :
ARTRA Fire Protection, email :
ARTRA Fire Protection, email :
7. DETECTION & ALARM RESET
DETECTION & ALARM RESET
DETECTION & ALARM RESET
DETECTION & ALARM RESET
Press the button (the side with the word "TEST" in the figure), and the buzzer "di di di" is
called three times. This feature indicates that the current smoke sensor is working and
working properly. It is recommended to perform a button test once a month to ensure that
the smoke alarm is in operation.
Press the button (the side with the word "REST" in the figure). When the smoke alarm
sounds an alarm, this function can stop the current smoke alarm and return to normal
operation. After confirming that the alarm is a false alarm, press this button as soon as
possible to cancel the alarm.
Warning : Do not place this product in flame to test the alarm function of this product. This
Warning :
Warning :
Warning :
is not only dangerous, but it is also very likely to damage the product. The only safe and
correct way to test is to use the test button for the alarm function test.
8. 8. 8. 8. REPLACE THE BATTERY
REPLACE THE BATTERY
REPLACE THE BATTERY
REPLACE THE BATTERY
When you hear a short beep every 60 seconds, this means your smoke sensor is already in
low battery. The low battery status will alert before the battery is completely drained, until
the battery is exhausted. This means you need to replace the battery immediately.
The steps to replace the battery are as follows :
1.
Remove the smoke sensor directly.
2.
Remove the battery from the inside of the battery compartment.
3.
Install a new battery, please refer to the "Start up" section for battery installation.
4.
After the battery is installed, push the smoke alarm up to the back cover and press
the button test. If an alarm sound is heard, the smoke alarm has started working.
5.
Install the battery to pay attention to the battery, positive and negative. Do not
reverse.
9. 9. 9. 9. ALARM REST
ALARM RESTR R R R ICTIONS
ALARM REST
ALARM REST
ICTIONS
ICTIONS
ICTIONS
This product can only detect smoke particles and temperature. Other gas such as
carbon monoxide, natural gas, and liquefied gas cannot be detected.
This product is battery powered and the battery type is 9V battery. Using other
types of battery power may cause damage to the device.
AR/DS/Doc-2010009
TECHNICAL DATA
TECHNICAL DATA
TECHNICAL DATA
TECHNICAL DATA
[email protected], support technis
, support technis http://www.artra.co.id/
, support technis
, support technis
WIRELESS SMOKE
DETECTOR CM90
http://www.artra.co.id/
http://www.artra.co.id/
http://www.artra.co.id/
5 |
P a g e