Cutting SQ30-2B Manuel - Sayfa 14

Kesici Cutting SQ30-2B için çevrimiçi göz atın veya pdf Manuel indirin. Cutting SQ30-2B 15 sayfaları. Portable electric pipe threader

Cutting SQ30-2B Manuel

Troubleshooting

Always unplug power cord before servicing threader.
PROBLEM
Motor does
not start
Motor sounds
overloaded
Sparks
forming at
motor
Die head does
not start
threading
Damaged
Thread
Support arm
turns while
threading
Die heads
cannot be
changed
properly
CAUSE
Threader unplugged
Brushes do not touch armature
Overload because of dull dies
Bad quality or insufficient thread
cutting oil
Bad contact between brushes and
brush holder
Brushes do not touch armature
properly
Sharp edge on brush
Dull or broken dies
Machine running in wrong direction
Improperly set dies
Dull dies
Dies not assembled in correct
sequence
Low quality pipe
Bad quality or insufficient thread
cutting oil
Support arm feed screw not tight
Support arm jaws dirty
Support arm not square on pipe
Burr has occurred at the spline end
of the die head
HANGZHOU HONGLI PIPE MACHINERY CO., LTD
CORRECTION
Plug into power source
Check brushes, replace if worn
Replace dies
Use thread cutting oil in adequate quantity
Tighten the screws, make sure brush is
pressed
firmly onto armature
Replace worn brushes
Break edge with sand paper
Replace dies
Check setting of the direction switch
Reset dies
Replace dies
Put dies in correct sequence
Make sure only pipe of good quality is used
Use only thread cutting oil in adequate
quantity
Tighten feed screw
Clean with wire brush
Make sure sits square on pipe
Eliminate burr with file
www.ccutting.cn
13