DLA DLA64 Kullanıcı Kılavuzu - Sayfa 3

Motor DLA DLA64 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DLA DLA64 7 sayfaları. Toplevel gasoline engine

This engine is not a toy! Serious injury and /or death can occur from its

misuse! READ and become familiar with this entire instruction manual.

LEARN the engine's applications, limitations, and possible hazards. DLA

is not responsible for any loss, injury or damage resulting from the

miss-use of its products.

1. Keep all spectators at least 30 feet away from the engine while operating the

engine.

2. Do not put anything (e.g. fingers, body parts, objects, et al) into the rotating

propeller

3. Wear proper apparel. Do not wear loose clothing, gloves, neckties, jewelry,

or neck straps ，which may get caught in the moving propeller.

4. Always wear eye protection when starting the engine.

5. Inspect engine mount bolts and firewall integrity before operating the motor.

6. Turn off the engine before making any adjustments.

7. Always use the proper size and well-conditioned propeller.

8. Always use the correct length propeller bolts and make sure they are tight

before every flight.(screw thread-locking glue is necessary)

9. Remember to keep engine fuel in a safe place, away from any

excessive

heat, or anything which could ignite the fuel.

gasoline/mixture is highly flammable and must be handled with extreme

caution. Do not smoke while running or operating the engine.

10. Do not run the engine near loose material such as dirt, gravel, power cords,

ropes, sand, etc.

injury or damage.

Engine installation

1. Make sure each engine comes with a firewall mounting plate drilled with four

holes for #10 size screws.

2. A spacer is needed to keep the cooling fins away from the firewall where the

firewall is larger than the engine plate.

3. In order to make sure the engine does not speed excessively without a

positive control installed,throttle return springs must be left in place.

4. After you have connected the return spring to the throttle servo you may

unhook it（do not remove it）, since it acts as a spacer for the butterfly. The

butterfly will work loose by removing the return spring.

5. The ignition battery should be mounted externally, near the cowl, at least

twelve inches from the receiver or throttle servo that connects to the

receiver.

6. The carburetor needs at least 1 1/2" (38mm) of clearance between the

intake and the bottom of the cowl. If there is less than 1 1/2", make an

opening in the cowl below the carb at least as large as the carb intake

Loose material can be drawn into the turning prop causing

sparks,

Remember that