DLab SK-D3309-Pro Servis Kılavuzu - Sayfa 8

Boya Püskürtücü DLab SK-D3309-Pro için çevrimiçi göz atın veya pdf Servis Kılavuzu indirin. DLab SK-D3309-Pro 9 sayfaları. Lcd digital 3d shaker

2.5 Replacement of power board component

Step 2:

Remove the 2 crews marked by

red circles and keep them well,

unplug the connector marked by

green circle, then replace photo

electronic switch;

Note: When you replaced new

photoelectronic switch, the Shaft

Encoder on the motor must

match

switch. When motor is turning,

Shaft

frictional

Photoelectronic.

Encoder is in place, lock it with

screws.

Step 3:

Remove the 3 screws marked by

red circles, take down the motor

and replace it.

As shown in the left figure, remove

the 5 screws marked by green circle,

take down the cables, remove the 2

screws marked by red circle, then

replace power board, assemble

cables in sequence.

with

photoelectronic

Encoder

cannot

contact

with

After

Shaft