CVap HBB Series Kullanıcı El Kitabı - Sayfa 3

LCD Çekmece CVap HBB Series için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. CVap HBB Series 8 sayfaları. Hold & serve drawer

Sayfayı Yazdır

CAUTION:

Can cause injury >>

switching device.

___________________________________________

In order to avoid a hazard due to inadvertent reseting of

the thermal cutout, this appliance must not be supplied

through an external switching device, such as a timer, or

connected to a circuit that is regularly switched on and off

by the utility.

___________________________________________

CAUTION:

Can cause injury >>

Allow 30 minutes for appliance to cool before

attempting to clean.

___________________________________________

Always allow appliance to cool before cleaning to avoid

potential burns.

___________________________________________

CAUTION:

Grease Hazard

Can cause damage to appliance >>

placing appliance near high heat or in grease-laden atmosphere.

___________________________________________

Do not place appliance in areas where air temperature

exceeds 100˚F (38˚C). A heat shield may be required to

prevent heat exposure and grease-laden vapors from

affecting the appliance if near heat, vapor, or grease

generating devices (such as grills, steamers, ovens, etc.).

Excess heat and grease inside the appliance cavities may

cause electrical components to fail.

WATER FILL PROCEDURE

The CVap® HBB hold and Serve drawer can be filled with

water via the Easy Fill Spout located on the front of the unit.

Simply pour warm water into the spout until the unit is filled

to the appropriate level before turning on the power. Refer to

page 4 for specfic water requirement instructions.

The CVap logo is a trademark of Winston Industries LLC. All other company and product names may be trademarks of their respective companies.

NEED TO CONTACT US?

www.winstonindustries.com • E-mail [email protected] | Mail 2345 Carton Drive | Louisville, KY 40299 USA

HBB HOLD & SERVE DRAWER

Electrical Hazard

Do not connect appliance to an external

Burn Hazard

High Temperature &

Phone 1.800.234.5286 | 1.502.495.5400 | Fax 1.502.495.5458

In order to operate properly, the evaporator in this

appliance must be filled with clean, potable water.

WARNING: Operation of Water Fill System requires that

evaporator be filled to water line prior to turning switch on.

CAUTION:

Can cause injury

If automatic water fill is not installed, the unit will require

refilling at various points during use. WARNING: do not

overfill the unit. Overfilling can create a vacuum causing hot

water to splash out of the Easy Fill Spout onto the user.

1. Locate the Easy Fill Spout on the front of the unit.

2. Visually inspect the water level inside the spout.

3. If water is not visible at the bottom of the Easy Fill

Spout it is time to top off the water level to ensure the

unit continues to operate properly.

4. If the unit is filled correctly, water will be just visible at

the bottom of the fill spout.

Avoid

5. If the water level inside the Easy Fill Spout is filled half

way up the spout or more, the unit is too full. Open the

drain and allow water to drain until the water level is

barely visible at the bottom of the Easy Fill Spout.

Burn Hazard

Incorrect Water Level

Spout too full

Correct Water Level

Unit filled properly