DLE DLE130 Kullanıcı Kılavuzu - Sayfa 4

Motor DLE DLE130 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DLE DLE130 5 sayfaları.

increase the idle speed. Meanwhile, turn the Low-speed Needle (See No.4)

clockwise to reduce the oil. Normally, screw the needle to the fully stop/closed

position and then open the needle back 1.5 turns. High-speed Needle (See No.5)

turns back about 1.0 turns. It is recommended that High-speed Needle be adjusted

by the use of the tachometer to obtain the maximum speed and smooth accelerate

and decelerate.

 调整化油器高速油针时请注意：混合气调整过稀将导致发动机严重过热和火花

塞烧毁。大油门燃烧后火花塞的颜色应该是黄色，说明混合气浓度比较合适。

混合气调整过浓时，特别是高速油针的调整，发动机快速收油门容易熄火。

Attention when adjust the High-speed Needle: Lean mixture will lead to

serious overheating and burn up of the sparkle plug. The suitable density of the

gas mixture comes when the color of the ignition plug is yellow after combustion.

Rich mixture, especially by adjustment of High-speed Needle, will lead to engine

shut off when close the throttle rapidly.

四、发动机的启动 (ENGINE START)

1. 关闭风门，加大油门，打开点火电源。

Close the Choke and turn on the ignition, advance throttle to full position.

2. 用力转动螺旋桨，（最好用启动棒）直到发动机发出爆炸声，发动机会运

转1-2秒而自动熄火。（首次启动或长时间不用可能需要转动多次螺旋桨）。

Briskly flip the propeller, better to use start-up rod, until the engine sound is

heard. The engine might shut down automatically in one or two seconds. It

may take a few more flips if this is the first time to start the engine or the

engine is stored for a long period.

3. 打开风门，油门开至怠速或比怠速稍大一点，启动发动机，进入正常工作

状态。

Open the choke and increase the throttle to slightly above the idle, the engine

should start and run smoothly.

4. 热车启动：打开风门，油门开至怠速或比怠速稍大一点，直接启动发动机。

Hot engine start: Open the choke and increase the throttle to the idle or slightly

above the idle, and then start the engine directly.

五、发动机的保养 (ENGINE MAINTENANCE)

1. 请使用清洁的92＃及以上无铅汽油，和机油的比例为30:1。禁止不同厂家、

牌号的润滑油混合使用，否则将会引起化油器严重阻塞。