Alutech Sun Shield EM3430L Kullanım Kılavuzu - Sayfa 11

Aksesuarlar Alutech Sun Shield EM3430L için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Alutech Sun Shield EM3430L 13 sayfaları. Retractable awning

Sayfayı Yazdır

Engine setting(off/on setting)

Factory default setting is best for the engine .

Larger settings before its use should therefore not be necessary. In the following cases, however,

the engine should be a bit readjusted if:

1 Theawningdoesn`t

2 The cover isloose.

3 The engine is not running yet, although the awning is fully closed.

Change the maximum distance of the awning, by using the enclosed tool. Use the motor

adjustment tool to adjust the motor,.

Use the front motor adjustment screw to adjust the maximum distance (see Figure M).

Turn the adjustment screw with the tool in counterclockwise direction "+" to increase the maximum

distance.

Turn the adjustment screw with the tool 20 in a clockwise

maximum distance.

Use the rear adjustment screw to adjust the minimum distance(see FigureN).

Turn the adjustment screw withthetool

the minimum distance.

Turn the adjustment screw withthetool

distance.

NOTE: If the motor does not start on after repeated on setting, please wait 30 minutes and start it

again afterwards.

NOTE: Over loading the motor is not good. Doing so may shorten its lifespan.

Handling of the remote control

Note: There are legal limitations for the transmission range of radio waves. The maximum range is

also limited by physical obstacles.

Before installing, check whether the remote device and the awning are working correctly ,Before you

install the hooks.

To allow reaching almost every vertical area below.

Make sure that the mount is in a place to install the corresponding prescribed protection (IP 20) of

the remote .

Do not mount on metal or magnetic objects to avoidinterference.

Battery/Use

NOTE: When you insert the battery make sure that the contacts are not bent.

Open the battery compartment with the spanner in the battery compartment lid in the direction of

the battery compartment and press the battery compartment cover , then the battery

compartment

Put the battery in accordance with polarity and labeling in thebattery

Close the battery compartment , by clicking the two extensions of the battery compartment lid in

the two cutouts on the battery compartment.

Then press the skewer of the battery compartment lid into the hole at the battery compartment.

The battery compartment cover snaps in with a click.

If the remote control could not function, then check whether the batteries are inserted correctly

and put them again if necessary.

completely.

slides.

in counter-clockwise direction "+" in order to increase

in clockwise direction "-" to reduce the minimum

direction "-" to reduce the