ALUZ A8-ZIZA-TAPE Kurulum Talimatları Kılavuzu - Sayfa 8

Aydınlatma Ekipmanları ALUZ A8-ZIZA-TAPE için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. ALUZ A8-ZIZA-TAPE 11 sayfaları. Led tape
Ayrıca ALUZ A8-ZIZA-TAPE için: Manuel (14 sayfalar)

Sayfayı Yazdır
ZIZA
Tape
A8-ZIZA-TAPE
1
Measure area where luminaire will be installed. Use a laser line to create
a reference line along installation area, ensuring consistent alignment
of mounting channels. Mark location where mounting channels will be
installed along reference line.
2
Lay extrusions along chalk line and drill at least 3 countersink holes per
extrusion. Drill additional holes as needed.
3
Screw extrusions to surface using countersink screws.
Note: Ensure extrusions are aligned. Misalignment will prevent lens from
snapping in.
Extrusions aligned
4
After all extrusions have been securely mounted, remove adhesive backing
from lightstrip and adhere in place along extrusion channel, ensuring
lightstrip is secure inside extrusion.
Note: Refer to Application Guidelines to ensure correct installation.
Countersink hole
Countersink screw
Install lightstrip into extrusions
Remove adhesive backing
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
Mounting Lightstrip (Dry Location Mounting Channel)
5
Ensure lightstrip is secured in place and is free of twists, tangles, creases,
or bumps.
6
If applicable, connect disconnects between luminaires or solder connectors
using the steps from Application Guidelines.
7
Perform a continuity test before connecting luminaire to power source.
Installation Instructions
9 / 1 / 2021 / Rev 0
Page 8 of 11
Ensure lightstrip
is secured in place