DLS Performance series Nasıl Kurulur ve Çalıştırılır - Sayfa 7
Araba Amplifikatörü DLS Performance series için çevrimiçi göz atın veya pdf Nasıl Kurulur ve Çalıştırılır indirin. DLS Performance series 16 sayfaları. Reference series car audio speakers
Ayrıca DLS Performance series için: Kullanıcı El Kitabı (12 sayfalar), Kullanıcı El Kitabı (4 sayfalar), Kullanıcı El Kitabı (4 sayfalar)
Sayfayı Yazdır
Crossovers of CA31, CA41 & CA51
CA-51
The CA41 is a four channel amplifier. It is mostly
used with a front system connected to channels C/
D and a subwoofer connected to channel A/B. You
will find speaker wiring and filter setting example on
page 10. Please observe the proper settings of the
channel A/B LPF multiplier switch and of the channel
C/D HPF multiplier switch.
The CA41 can also be used to feed a 2–way front
system with active crossovers between midbasses
and tweeters. This is described in a speaker wiring
and filter setting example on page 11.
LPF
Multiply
80/800Hz
200/2(k)Hz
x1 x10
Off On
50/500Hz 500/5(k)Hz
Off On
Channel A/B is equipped very much like the CA22
and CA23, however the LPF has a multiplier. Thus
the frequency range of the LPF can be varied from
50 Hz – 500 Hz in the x1 position or 500 Hz – 5 kHz
in the x10 position. This way we can use this
amplifier to feed a 2-way system, where the
midbasses are feed from 80 Hz – 4 kHz.
The tweeters connected to channel C/D , operate
from 4 kHz upwards using the HPF in multiplier po-
sition x 10 150 Hz – 5 kHz.
HPF
Multiply
50/500Hz 220/2(k)Hz
x1 x10
15/150Hz 500/5(k)Hz
CA22, 23, 31, 41 & 51
The CA31 is a three channel amplifier. It has a
variable high pass filter, 50-150 Hz, for channel A/
B. The C channel is for subwoofers and has a
subsonic filter, a variable low pass filter, 50-120 Hz,
and a phase control variable from 0 - 180 degrees.
The subsonic filter can be switched IN-OUT and has
a fixed frequency of 25 Hz.
The CA51 is a five channel amplifier. On channel
A/B, C/D the filter configuration is exactly the same
as for CA41.
Channel E is a subwoofer mono channel with a
lowpass filter adjustable from 60 to 120 Hz. Channel
E has also a subsonic filter that can be switched IN-
OUT. The subsonic filter has a fixed frequency of
25 Hz. The CA51 has also a phase control variable
from 0 - 180 degrees.
7