10 Bar Underwater Housings 5 D Mark II Kullanıcı Kılavuzu - Sayfa 9

Kamera Aksesuarları 10 Bar Underwater Housings 5 D Mark II için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 10 Bar Underwater Housings 5 D Mark II 10 sayfaları.

Sayfayı Yazdır

5.2

General Operation.

The control levers and push buttons consist of internal double O-ring seals on a stainless steel

shaft. This arrangement is very reliable, however as a precaution, when operating the controls, avoid

excessively rapid movements, as this may distort the O-ring. Also please allow for the fact that the camera

takes a few seconds to power on. If the camera dose not appear to respond to a control action, make sure

that no other controls are pressing on the camera, i.e. locking out further actions. Wear the wrist strap; it

is easy to inadvertently let go of the housing, especially if you are distracted.

5.3 Cleaning & Storage.

The body & lid of the housing are made of polycarbonate. Polycarbonate was selected for its outstanding strength stiffness,

hardness and toughness. As well as its crystal clear transparency and high gloss surface. It has good resistance to weathering,

although long-term exposure to sunlight should be avoided. Normal operating temperature range is 3°C to 36°C (Storage

temperature: -10°C to 50°C)

It is good practice to rinse off your housing with fresh water after every dive. Avoid exposure to fine sand. After a series of

10 or more dives, e.g. after a dive holiday, it is recommended to immerse the housing for 2-3 hours in warm water to

dissolve any salt deposits that may have built up. No chemical cleaners should be used. Mild detergents e.g. shampoo and

soap based cleaners are permitted.

Important !!!

Some household chemicals may harm Polycarbonate; the housing should never be exposed to the

following classes of chemicals: benzene, toluene, xylene, chlorinated hydrocarbons, methanol, any

other solvents, strong acids and bases.

For long term storage please remove the main o-ring from body.

5.4 Transportation.

When transporting by air, please ensure the housing is not sealed, to allow the air pressure to equalize. Either remove the O

-ring (recommended), or open the pressure release port (a spacer is provided to keep the pressure plug in the open position,

please make sure there is no bending of the plug while open).

Please protect the housing during transportation. It is recommended to remove the sync cord, and wrap the housing in foam

or bubble wrap.

5.5 Accidents.

The impact resistance of the housing is excellent. However after an accident the alignment of the housing may have been

damaged. Therefore in the event of your housing suffering an impact force, e.g. being dropped, it is essential you do not use

the housing for diving. Please return the housing immediately for service. Please put a note inside to indicate the nature of

the accident, so that we can assess the severity.

6. Service

To ensure the continued performance of your housing, it should be serviced every year, or after every 200 dives.

note the terms for servicing the housing posted at our website. A full service will include:

•

Inspection of all components for wears or damage (report if repair necessary)

•

Cleaning of all sealing surfaces, and replacement of all O-ring seals.

•

Hydrostatic pressure test to 10 Bar.

Note: the replacement of damaged components (except replacement O-rings) may require additional cost.

Please