DNF Controls 2MCE-24P Kullanıcı Kılavuzları - Sayfa 14

Kontrolör DNF Controls 2MCE-24P için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzları indirin. DNF Controls 2MCE-24P 19 sayfaları. Two machine, cuts only editor with 24p editing capability

Sayfayı Yazdır

Reference . . .

SETUP MENU

Press [MENU]. The MENU indicator will turn on. Turn the Wheel to select item to change.

Press [ESC] at anytime to exit SETUP MENU. The MENU indicator will turn off.

MENU MODES

RECORD MODE

SLOMO SPEED

RANGE

SLOMO PRESET

MAX WIND SPEED

WIND MODE

VIDEO STANDARD

RECORD

DISPLAY SOFTWARE

VERSION

CLEAR MEMORY

SET FACTORY

DEFAULTS

2MCE-24P, Two Machine, Cuts Only Editor

(Turning Wheel clockwise)

Press [MENU] to select the desired record mode: Lockout, Crash (Full).

Only in INSERT mode: Press the associated Softkey, located below the

display, to toggle Video(V), Audio1(A1), Audio2(A2), Audio3(A3),

Audio4(A4) on/off.

Press [MENU] to select the desired speed range:

-100

+200 or 0

Press [MENU] to select the desired mode: UPDATE or STATIC

UPDATE - When exiting OFFSPEED mode, the last used speed is saved in

the

Preset Speed register.

STATIC - The Preset Speed register is NOT updated when the wheel is

turned. Upon entering OFFSPEED mode, the slomo speed is always restored

to the preset value set by [SHIFT] + [SLOMO].

Press [MENU] to select the desired maximum wind speed.

Press [MENU] to select the desired wind mode, LATCH or HOLD.

LATCH - Fast wind is initiated and maintained with a momentary key press.

HOLD - Fast wind is initiated and maintained only while key is pressed.

Upon releasing key, wind mode terminates.

Press a Softkey to select the desired video standard – PAL, NTSC or 24P.

Press Softkey to select single button or 2-button record.

RECORD = [REC] Only OR RECORD = [REC] + [PLAY]

The version number for the currently installed software is displayed.

Press [DEL] to clear the controller's internal memory. Press [ESC] to exit

without clearing memory.

Press [DEL] to initialize the controller to factory defaults.

Press [ESC] to exit without initializing controller to factory defaults.

+200