DNF Controls 4000CL-L Kullanıcı Kılavuzu - Sayfa 12

Kontrolör DNF Controls 4000CL-L için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DNF Controls 4000CL-L 19 sayfaları. 400 clip fast access system using louth protocol

Sayfayı Yazdır
b.

RECEIVE CUE LIST FUNCTION

The RECEIVE CUE LIST function allows you to receive your list of Cue Points from a
PC or from another ST300. Transfer to a PC requires OpSuite 3.0 software, which runs
on a Windows-based computer. Contact DNF Controls for more information.
1)
2)
12
4000CL-L, Vs.2.1, 400 Clip Fast Access System, Louth Protocol
TO RECEIVE CUE POINTS FROM THE ST300
a)
Connect the VTR4 connector on the back of the ST300 from the VTR4
connector of the transmitting ST300 using RS422 9-pin cable with TX
and RX lines crossed. (A "Turnaround" Cable)
b)
Press [MENU].
c)
Scroll the wheel until "Receive CUE List? YES=Enter, Exit=ESC" is
displayed.
d)
Press [ENTER] to start receiving.
The Display shows "Waiting to receive" on the first line.
e)
When the Transmitter is ready, transfer starts automatically.
The display now shows "Receiving cuelist."
f)
After the transfer is over the display shows "Done-Success! Press any
key..."
g)
Press any key. The display shows "Receive cuelist?" message.
h)
Press [ESC] to exit the MENU mode.
TO RECEIVE CUE POINTS FROM THE PC
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using RS422 to RS232 adapter
b)
Repeat steps b – h of "TO RECEIVE CUE POINTS FROM THE
ST300," Section 11.b.1).