DNF Controls SW32PS-RCP Kullanıcı Kılavuzu - Sayfa 10

Kontrol Paneli DNF Controls SW32PS-RCP için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DNF Controls SW32PS-RCP 17 sayfaları. Rs422 port switcher remote control panel

Sayfayı Yazdır
f.

SETUP GANG

1)
2)
3)
4)
5)
6)
7)
8)
g.

DISCONNECT GANG

1)
2)
3)
4)
Page
6
O
f
1
3
6
O
f
1
3
Press [FROM]. The FROM indicator turns on. The left side of
the display shows the currently selected FROM connector
(PORT1-32).
Turn the Wheel to select the source port.
Press [TO]. The TO indicator turns on. The right side of the
display shows the currently selected TO connector (PORT1-32).
Press [GANG]. The GANG indicator turns on.
Turn the Wheel to select the destination port.
Press [TAKE] to route the selected input to the selected
destination. The second line of the display will show "PORT(X)
Added".
Repeat steps 5-6 to add additional routes to GANG.
Press [ESC] when done. FROM, TO and GANG indicators turn
OFF.
NOTE: The GANG function will only work properly if the GANG is
Enabled on the SW32PS. It is the responsibility of the user to
set GANG to Enabled in the SW32PS Setup Menu. (See the
SW32PS Port Switcher User Manual for the instructions on how
to enable / disable gang.)
Press [VIEW].
Turn the Wheel to find the GANG to be disconnected.
Press [GANG]. The display will prompt "Disconnect switches?"
Press [TAKE] to break all the routes that are part of gang.
OR
Press [ESC] to exit.
SW32PS-RCP Port Switcher Controller