Do-Right Solar SWS-200 Kullanıcı El Kitabı - Sayfa 14

İnvertör Do-Right Solar SWS-200 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Do-Right Solar SWS-200 19 sayfaları.

tubing still attached to the barb, using a razor blade, taking care not to damage the

barb.

Pull off the output hoses. Remove the tilt angle prop and close and latch the solar

still. Lift the still from the table or stand and set it down vertically on the ground

and allow it to fully drain. It helps to tilt it a little so water runs out one side.

Carry the still inside, and place it glass-pane down on a clean table, floor, or carpet.

Unlatch the still and fold the base fully open (90°). As you do so, you'll need to

first detach the safety chain.

Remove all the screws of the evaporator panel, either by hand or with an electric

screwdriver/drill. Before you can lift off the evaporator panel, though, you need to

break the suction that has developed in the seals. With the aid of a couple of blade

screwdrivers or chisels, start at one corner of the still and work your way around