dobar 35441E Kullanıcı El Kitabı - Sayfa 11

Dış Mekan Şömine dobar 35441E için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. dobar 35441E 11 sayfaları. Gas fire pit

Sayfayı Yazdır

TROUBLESHOOTING

Problem:

Condition:

Control knob is not in Maximum position (big

flame).

LPG cylinder valve is closed / Empty.

Blockage in the injector.

Burner won't

Air in the gas circuit.

light

Low gas pressure.

Igniter fails.

Dirty build up around burner.

Low flames or not full running around the

Burner won't stay

burner.

lit

Thermocouple is not operating correctly.

Low Gas pressure.

Outdoor temperature is greater than 5 ˚C

Burner flame is

and LPG cylinder is less than 25 % full.

low

Gas pipe is bent or kinked.

Note: Do not

operate appliance

Control knob is fully Maximum position (big

below 5 ˚C

flame).

Carbon build-up

Dirty or film on burner.

Flash back (flame

Burner ports are blocked.

inside burner)

Thick black

Blockage in the burner.

smoke

If you can not solve trouble according to one of the mentioned solution, please contact your dealer

or distributor responsible.

Solution suggested:

Turn control knob in Maximum position (big flame).

Open the valve / Replace LPG cylinder with a new one.

Clean or replace injector.

Open gas line and bleed it (pressing

control knob in) for not over 1 minute or until you smell gas.

Replace LPG cylinder with a new one.

Use match to light burner; change battery or obtain new

igniter and replace

it.

Clean dirty around the burner.

Flame spreader holes partially closed; clean the burner.

Replace thermocouple (FSD).

Replace LPG cylinder with a new one.

Straighten hose and perform leakage test on gas pipe.

Turn control knob to"OFF" position (full disk), let cool to

room temperature and check burner and

orifices for blockage.

Clean burner.

Switch OFF the appliance. Close LPG cylinder valve. Wait

2 minutes, following the ignition procedure. Ignite burner. If

problem continuous, switch-off. Contact your dealer.

Turn control knob to "OFF" position, let the appliance to

cool at room temperature and remove

blockage and clean burner inside and outside.

11 of 11