FLATLIFT EXTRA FLAT Kullanım Kılavuzu - Sayfa 6

TV Montajı FLATLIFT EXTRA FLAT için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. FLATLIFT EXTRA FLAT 16 sayfaları. 43" / 50"

O u t p e r f o r m . O u t l a s t .

Initial set up:

1. In order to prevent the system from tipping over, fix your Pop-Up installation base to the floor using 4

screws (image 1 no. 1).

2. Connect the Flatlift (image 1, no. 3) with the motor cables (P.07, image 3) and connect these with the

control box (image 2, no. 5) at connection point '1'. The motor cables must be connected starting

at port 1 and going up.

3. Connect the RJ-45 Western plug of the receiver (P.07, image 4, no. 7) to the control box (image 2, no. 6).

4. Connect the control box (image 2, no. 4) with the power cord (P.07, image 5) to the mains supply.

5. Connect the wall power supply of the receiver (image 2, no. 4) with the power cord (P.07, image 5) to the

mains supply.

6. Now initialise the Flatlift by pressing down the 'Down' key on the controller (P.07 image 6 no. 9) for 2 x 5

sec. After this, extend and retract your Flatlift fully twice over.

7. Your Flatlift is now ready for use as the end points of the lift have now been saved in the control box.

8. You are now able to mount your TV set on the system. To do this, uncouple the two holders (image 1 no.

2). Attach these to your TV and then secure the holder subsequent to putting the TV set in place by

screwing in the safety screw (image 1, no. 4).

If you separate the motor cable from the control box, then the Flatlift must be initialised all

over again.

Image 2

C.04:

Operating Manual

INITIAL PRODUCT SET U

P.06

INITIAL PRODUCT SET UP

Image 1