Dobinsons BU59-3511 Kurulum Kılavuzu - Sayfa 5
Otomobil Aksesuarları Dobinsons BU59-3511 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dobinsons BU59-3511 10 sayfaları. Bullbar
8. Ensure the bracket is central to the vehicle
and tighten all nuts and bolts installed in steps
5-7. Ensure when tightening that the u-bolts
have sufficient clearance to the radiator
support panel.
9. Carefully un-wrap the bulbar taking care not
to scratch it especially on the top loops.
Reinstall the number plate. If installing driving
lights to the bullbar it is easiest to install now.
10. If not installing a winch skip to step 19.
11. See the Installation section of your Dobinsons
4x4 Winch manual for specific detailed fitting
instructions. For a brief overview see the
following steps.
12. Test fit your winch to the mounting bracket
and do up loosely with the clutch handle on
the left hand side of the vehicle.
13. Some vehicles may also require the air
conditioner line to be relocated when
installing a winch. Unclip the passenger side
front mount, cut the mount shorter and drill a
Dobinsons Springs and Suspension
6mm hole at the top of the mount and re-clip
this to its new position.
14. This may require the clutch handle and gear-
box housing to be rotated forward one or 2
bolt holes to allow easy access through the
bulbar holes. See instructions in winch user
manual.
15. Determine where the winch control box will
be located and mount the control box. See
instructions in winch user manual for control
box mounting options. If mounting to the top
of the bullbar using the supplied bracket,
check clearance of control box to grill and also
check where the wires will route as if the
wires are passing through the holes in the top
of the bullbar the control box may not be able
to be wired until the bullbar has been fitted as
below.
16. Wire the winch up as per the winch
instruction manual and bolt the winch to the
mounting bracket, ensure the mounting bolts
are not too long and tighten correctly. Route
www.dobinsonsprings.com