Dobinsons BU59-3668 Kurulum Kılavuzu - Sayfa 4

Otomobil Aksesuarları Dobinsons BU59-3668 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dobinsons BU59-3668 9 sayfaları. Bullbar for toyota landcruiser 80 series

Sayfayı Yazdır

Fitting Guide

1. Remove the number plate.

2. Remove the bumper bar or factory bullbar if

fitted.

3. Remove the factory tow hooks and keep

aside.

4. Install the bullbar mounting bracket and

winch mounting frame as per the diagram on

page 3.

5. Install all bolts and tighten. The factory tow

hooks can be re-fitted under the winch

mounting frame, using the original bolts.

NOTE: 80 series landcruisers are released with

slightly varying chassis heights between

models. For this reason you may have to place

packing washers between the top of the

chassis rail and inside of brackets to take up

the gap.

6. Carefully un-wrap the bulbar taking care not

to scratch it especially on the top loops.

Reinstall the number plate. If installing driving

lights to the bullbar it is easiest to install now.

7. If not installing a winch skip to step 15.

Dobinsons Springs and Suspension

8. See the Installation section of your Dobinsons

4x4 Winch manual for specific detailed fitting

instructions. For a brief overview see the

following steps.

9. Test fit your winch to the mounting bracket

and do up loosely with the clutch handle on

the left hand side of the vehicle.

10. This may require the clutch handle and gear-

box housing to be rotated forward one or 2

bolt holes to allow easy access through the

bulbar holes. See instructions in winch user

manual.

11. Determine where the winch control box will

be located and mount the control box. See

instructions in winch user manual for control

box mounting options. If mounting to the top

of the bullbar using the supplied bracket,

check clearance of control box to grill and also

check where the wires will route as if the

wires are passing through the holes in the top

of the bullbar the control box may not be able

to be wired until the bullbar has been fitted as

below.

12. Wire the winch up as per the winch

instruction manual and bolt the winch to the

mounting bracket, ensure the mounting bolts

are not too long and tighten correctly. Route

the wires and connect to battery and also

route the breather hose.

13. Unwind some cable from the winch, and pass

the cable through the fairlead hole in the

bullbar and through the roller fairlead. This