FLAVIA Creation 400 Kullanıcı Kılavuzu - Sayfa 11
Kahve Makinesi FLAVIA Creation 400 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. FLAVIA Creation 400 12 sayfaları.
Ayrıca FLAVIA Creation 400 için: Kullanıcı Kılavuzu (15 sayfalar), Yeniden Başlatma Talimatları (2 sayfalar)
Sayfayı Yazdır
70-41-2651 iss4 UK C400 User Guide.qxd:OPS Guide US CAN Amend.qxd
D A I L Y C A R E
EMPTYING THE DRIP TRAY
1. Lift out and empty drip tray. CAUTION – CONTENTS MAY BE HOT
2. Separate drip tray and cup stand
3. Clean them in warm soapy water, wipe area left by drip tray
4. Reassemble and replace carefully
WARNING - HANDLE DRIP TRAY AS REF. A
•
Notice
The brewer does not tell you when the drip
tray is full so make sure you check it regularly
EMPTYING THE FILTERPACK BIN
1. Remove drip tray
2. Pull bin forward
3. Empty filterpack bin
4. Clean bin in warm, soapy
water
5. Replace bin
6. Replace drip tray
Notice
•
If filterpack bin fills right up, the "check bin" message will be displayed
•
If your FLAVIA® brewer is on a base unit, the "check bin" message will not be displayed
REFILLING WITH WATER (Manual fill only)
1. Lift the filler lid
2. Fill with water
3. Maximum fill level reached when the red float cap pops up
4. Close the filler flap
Notice
•
Only use cold water when refilling
•
Take care not to overfill tank
•
If tank runs out before water is refilled, the
display will read "ADD WATER"
•
If tank is overfilled water will flow out from
underneath filterpack door and into drip tray *
* Only applies to models of brewer with an air duct fitted
1/5/09
15:26
Page 20
Ref. A
Notice
•
Take care when removing filterpack bin
•
The act of removing the bin resets
the bin counter - Always empty the
bin if removed
7
W E E K L Y C A R E
GENERAL CLEANING
Use a damp cloth to wipe the outside surfaces and the areas that are exposed inside.
Notice
•
Do not use strong detergents and take care not to get soapy water into the water tank as
this will affect the drink taste
CLEANING THE WATER FILLER FUNNEL
1. Open filler lid
2. Remove filler funnel assembly
3. Clean them
4. Rinse thoroughly (so no soap
gets into tank)
5. Replace
6. Close the filler flap
CLEANING THE FILTERPACK DOOR
1. Grip bottom of filterpack door
2. Use other hand to steady the brewer.
3. Pull sharply from bottom towards you
4. Wash in warm soapy water and rinse
thoroughly
5. Wipe sides of area where door was
6. Replace door – Top first
7. Push bottom of door until you hear
a 'CLICK'
CLEANING THE CUP DETECT AND AIR DUCT
Ensure sensor is wiped clean
Ensure air duct is clean and
and not obstructed
free of debris
SANITISING
•
After cleaning, sanitise surfaces with a non-chlorine based anti-bacterial wipe or solution.
•
Avoid scented products, as this will affect the drink taste.
8
Notice
•
Remove filterpack
door to access air
duct