Aiper Seagull 600 Kullanıcı Kılavuzu - Sayfa 16

Yüzme Havuzu Vakumu Aiper Seagull 600 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aiper Seagull 600 20 sayfaları. Robotic pool cleaner

Sayfayı Yazdır
Aiper Seagull 600 Kullanıcı Kılavuzu
Q: The robot can not run for 50 minutes.
A:
1. Check if the battery is fully charged before use.
2. The max battery life is 55 minutes, it will generally stop cleaning in
about 50 minutes;
3. For example, the battery life is 55 minutes, if the last time was used
for 30 minutes, then there is only about 20 minutes left this time;
4. Check if the machine gets stuck in one place and whether it has been
idling, consuming power.
5. If all above is checked but the machine still runs far under 50 minutes,
please contact customer service to replace the drive kit or machine.
Q: The robot only goes in one direction even if it's fully charged, and it
will not reverse when touching the wall
A:1. Check if the flapper of the water outlet is stuck or blocked;
2. Take out the driver kit and start it separately to see if there is any
abnormality (if possible);
3. If there is no other abnormality, it should be something wrong with
the sensor and the machine or driver kit needs to be replaced.
Q: The robot stops or gets stuck
A: PS: the product itself does not have the ability to cross obstacles.
You can do as below:
1. When it stops, check if the water inlet flapper is stuck;
2. Check whether the bottom of the pool is a bumpy one;
3. Check if it is a pool with a pebble bottom;
4. Check if there are other objects stuck at the bottom of the machine.
Q: The robot becomes slower in operation and its suction becomes
weaker
A:Clean the filter and check if the pool is too dirty. If so, it is recommended
to clean it manually first, and then use the product for daily
maintenance.
Q: The charging pin is corroded because of electrolysis
A:Please replace the driver kit for this condition. And please mind that
after each use, wipe the charging pin. Clean and dry it with a paper
towel or cotton swab. Wait for a few minutes to let the moisture dry
out before charging it.
12