Fleet Complete AT1000 Kendi Kendine Kurulum Kılavuzu - Sayfa 3

GPS Fleet Complete AT1000 için çevrimiçi göz atın veya pdf Kendi Kendine Kurulum Kılavuzu indirin. Fleet Complete AT1000 4 sayfaları. Asset tracker

4. Use nylon cable ties to secure the unit.

5. The AT1000 has four cables in the pigtail

cable harness:

a) Power (Red Wire)

b) Ground (Black Wire)

c) Input #1 (Orange)

d) Input #2 (Brown)

NOTE: If input wires are not used, wrap or tape

the wires separately to avoid short circuiting and

battery drainage.

6. Connect the unit to the external power

source:

• Power (Red Wire)

• Ground (Black Wire)

NOTE: The unit is adapted for 9-32V power supply.

ACTIVATION

To activate the unit, perform the following steps:

1. While the unit is in cradle (the Tamper Switch is pressed) press the

Emergency Button for at least 3 seconds. The Power LED will glow for

3 seconds.

2. After the Power LED ceases glowing, and the Network/Cell LED blinks,

stop pressing the Emergency button.

3. Verify that the Power LED blinks twice. This indicates successful

Network/Cell communication with the control center.

DEACTIVATION

To deactivate the unit, perform the following steps:

1. Dismount the unit from the cradle. Make sure the tamper switch is not

pressed.

2. Press the Emergency Button for at least 3 seconds. While the Emergency

Button is pressed, the Power LED glows for 2 seconds.

3. After the Power LED ceases glowing, stop pressing the Emergency Button.

For technical support call 1 800 220 0779 |