ETA Systems PD8 Kullanıcı El Kitabı ve Kullanım Talimatları

Güç dağıtım ünitesi ETA Systems PD8 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı ve Kullanım Talimatları indirin. ETA Systems PD8 2 sayfaları. Eta systems conditioned power distribution unit owner's manual
Ayrıca ETA Systems PD8 için: Teknik Özellikler (4 sayfalar)

Sayfayı Yazdır

June 2000

OWNER'S MANUAL

OPERATION INSTRUCTIONS

ETA's line of Conditioned Power

Distribution units are designed to

prevent electrical damage to sensitive

electronic equipment from high

amplitude/short duration spikes,

random surges, and EMI/RFI noise,

which is inherent in utility power lines.

Power line sources which are not

preconditioned or filtered can affect

reliable operation of sensitive audio,

computer, and other electronic

equipment, and may cause premature

failure, expensive repairs, or unan-

ticipated replacement from non-

repairable damage.

As inherent problems in utility AC

power lines increase for various

reasons, and the need for noise-free,

conditioned power increases, ETA is

there with the units to protect your

valuable electronic equipment. With

present demands on the power utilities,

voltage spikes, power surges, electri-

cal noise, and power failures are

commonplace. This "garbage" in the

power delivered can reduce the fidelity

of audio systems, cause premature

A Creative Light & Sound Company

Division of National Biological Corporation

1532 Enterprise Parkway • Twinsburg, Ohio 44087 USA

330-425-3388 • 800-321-6699 • Fax: 330-425-9700

http://www.etasys.com

LIGH TS

HIGH

OFF

LOW

failure, or result in extensive damage

or destruction of electronic equipment.

ETA Conditioned Power Distribu-

tion units feature a master power switch,

conveniently located on the front control

panel, that switches the rear panel AC

outlets ON and OFF. An LED next to

the master power switch indicates the

power conditioning circuitry is working

and the rear panel AC outlets are

powered. Maximum total wattage input

is 1800 watts and the 8 power output

receptacles are protected with a 15-

amp (total unit) resettable circuit

breaker.

Note: The front panel LED is

normally lit when the power switch is in

the ON position. If the power switch is

ON and the LED is not lit, power may

still be present on the output AC

receptacles, but the power conditioning

circuitry is not working. Do not continue

use of the power conditioning unit and

refer trouble-shooting to a qualified

electronic technician or contact ETA

Customer Service for assistance.

SYSTEMS

E-mail [email protected]

CIRCU IT BREAK ER

ON / OFF

PROT ECTIO N ON

ON / OFF

CIRCU IT BREAK ER

PROT ECTIO N ON

EASY INSTALLATION

The PD8 and PD8L is easily mounted

into a standard 19-inch rack or placed

into a free-standing position. With the

PD master power switch in the OFF

position, plug the line cord into a

convenient AC receptacle. Place the

PD8 power switch into the ON position

and check that the front panel LED is lit.

The lit LED indicates conditioned and

filtered AC power is connected. Then,

with their master power switches in the

OFF position, plug the equipment to be

protected into the PD's rear panel AC

receptacles. Turn on the power switches

of the equipment plugged into the PD8.

8 L

BACK PANEL PD8/PD8L