ETA Systems ETA-S20RT Manuel - Sayfa 9

AC Güç Dağıtımı ETA Systems ETA-S20RT için çevrimiçi göz atın veya pdf Manuel indirin. ETA Systems ETA-S20RT 12 sayfaları. Ac power distribution & ac suppressor unit with remote activation

Sayfayı Yazdır

INSTALLATION

Before installing, it is recommended to read the entire manual to ensure proper operation and that all features are being utilized. The

ETA-S20RT can be placed on a shelf or rack mounted in a standard 19" width rack. When rack mounted, placement within the rack is

flexible however the ETA-S20RT should be within 6' of a dedicated 20A AC outlet. When rack mounting, use Rack Rail type screws of

⁄

" x 1". Always make sure the 20A outlet is properly inspected by a certified electrician prior to connecting the ETA-S20RT. Make sure

to inspect the equipment that will be connected to the ETA-S20RT to ensure it does not exceed 20A total amperage draw.

Remote Activation Connections Diagram

ETA-S20RT

AC Distribution & Suppressor Unit

Remote Activation via Hard Contact Switch

Use External Key or Panel Switch, Hard Contact

To Remote Panel LED, Use the +12 and GND Terminals.

Note: Use a 2K ohm

Remote Voltage Activation

Apply +5V–24VDC and Connect a Ground to the GND Terminal

to Activate the Unit.

Note: It is OK to Have Two Wires In the Same Terminal.

To Remote Panel LED, Use the +12 and GND Terminals.

Note: Use a 2K ohm

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800-321-6699 • Fax: 800-996-3821

– 9 –

Specifications are subject to change without notice.

⁄

W Resistor In Series with +12VDC and LED

⁄

W Resistor In Series with +12VDC and LED

ETAsys.com