Fleetworks FLTW-7633 Kurulum Talimatları

Araç Kameraları Fleetworks FLTW-7633 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Fleetworks FLTW-7633 5 sayfaları. 2013 - current ram truck rear vision parkline camera with rca and factory display harnesse

Sayfayı Yazdır

2013-Current RAM Truck Rear Vision

RCA and Factory Display Harnesses (Kit part number

FLTW-7633)

Kit Contents:

Chassis Harness

1 bubble bag containing:

Tailgate Handle Camera

1 bag containing:

8.4" Factory Touch Screen Jumper Harness

2 pieces ½" glued heat shrink tube

These instructions

Note: We strive to provide accurate and up-to-date installation instructions.

IMPORTANT: Verify kit contents are complete against list above before beginning installation.

Preparation

1. Ensure all lamps and accessories are OFF.

2. Ensure ignition switch is in the OFF position.

3. Loosen negative battery cable bolt. Remove

negative battery cable from terminal and position

away from battery

4. Wait one (1) minute prior to working on vehicle to

assure SIR roof rail airbag system has been disabled

for your safety

Install Camera into Tailgate

5. Lower Tailgate and (if equipped) remove plastic

Tailgate Protector.

6. Remove the Tailgate Access Panel. (Figure 1)

I NSTALLATION I NSTRUCTIONS

Parkline Camera

Tools & Supplies Required:

Socket Wrench or Socket Driver

Plastic Trim Removal Tool

Phillips and Flat Blade Screwdrivers

Power Drill

Center Punch

Heat Shrink Tubing

Soldering Iron and Solder

Heat Gun

Corrosion Inhibitor

Wire Ties

Figure 1

with

(recommended)

(optional)

(recommended)

or Electrical Tape

or T-taps