Clinispin Horizon 755VES Operatör El Kitabı - Sayfa 7

Laboratuvar Ekipmanları Clinispin Horizon 755VES için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. Clinispin Horizon 755VES 16 sayfaları. Laboratory centrifuge

Sayfayı Yazdır

iniTiAl sETup prOcEdurE (continued):

12. Press the 'OPEN / STOP' button to terminate the test run. The rotor will decelerate to a

complete stop and the lid will then unlock automatically for sixty (60) seconds.

13. The centrifuge is now ready for operation.

OpErATiOn:

nOTE: Follow the initial setup procedure before initial operation.

1. Press the 'OPEN / STOP' button to unlock the lid and then open the lid.

Place the test tube samples into the tube carriers. Be sure to follow the rules for

balanced loads.

Close the lid and turn the lid knob clockwise to its complete stop position. The

LOCKED' indicator light should illuminate to indicate that the latch is closed

properly. If the lid knob is not completely latched, the 'LOCKED' indicator light will not

illuminate and the centrifuge cannot be operated.

4. Set the desired speed and run time using the appropriate up and down arrow buttons.

5. Begin the run by pressing the 'START' button on the control panel.

6. The centrifuge should begin to spin. The 'RUNNING' indicator light should illuminate.

IF A PROBLEM IS FOUND DURING A SPIN THAT REQUIRES THE CENTRIFUGE

TO SHUT DOWN, PRESS THE 'OPEN / STOP' BUTTON IMMEDIATELY !

7. After time has elapsed, the 'RUNNING' indicator light will extinguish and the rotor will

decelerate to a complete stop.

8. The 'UNLOCKED' indicator light will illuminate and the locking mechanism will

disengage, allowing entry into

after 60 seconds) simply press the 'OPEN / STOP' button.

Turn the lid knob counterclockwise and open the lid.

10. Remove the samples.

11. The centrifuge may be used immediately.

the rotor chamber. If the automatic unlock times out

page 7