Clinton Electronics CE-CC110 Manuel - Sayfa 8

Renkli Kamera Clinton Electronics CE-CC110 için çevrimiçi göz atın veya pdf Manuel indirin. Clinton Electronics CE-CC110 19 sayfaları.

Sayfayı Yazdır

■ Installation

■ Lens

The camera is supplied without a lens. Lenses, such as auto iris,

CS-Mount and C-Mount, can be used.

Note

ㆍ Using a DC auto iris lens is recommended to achieve the best

possible results from the camera.

ㆍ Please keep the lens clean.

ㆍ Foreign objects or fingerprints on the lens will result in inferior image

quality, especially in low light level conditions.

Using the auto iris

1. Strip back about 8mm of the outer sheath of the auto iris lens cable.

2. Strip off about 2mm of the insulation of wires inside the

lens cable.

High Resolution Color Camera

3. Remove the cover of the auto iris lens connection plug and solder the

wires to the connector pins inside the plug, as shown below.

Pin No.

Pin No.1

Damping Coil-

Pin No.2

Damping Coil+

Pin No.3

Drive+

Pin No.4

Dreve-

4. Replace the auto iris lens connection plug cover. Remove the lens

protection cap and then attach the auto iris lens to the camera by

screwing it in clockwise.

5. Insert the connection plug connected to the auto iris lens cable into

the auto lens connector jack, which is located on the rear of the camera.

6. Set the lens selection switch, located on

the rear of the camera, to either DC or VIDEO,

depending on the type of auto iris lens being

used.

Installation ■

LENS

VIDEO

Red (power)

White (video signal)

Black (GND)

OSD EXTRA

IRIS JACK

VIDEO OUT

POWER

SET

VIDEO

AC 24V IN

DC12V IN

High Resolution Color Camera