CLINTON INDUSTRIES 1190E Manuel - Sayfa 12

Kontrolör CLINTON INDUSTRIES 1190E için çevrimiçi göz atın veya pdf Manuel indirin. CLINTON INDUSTRIES 1190E 19 sayfaları.

To go to the next group, press the "ARROW-ROUND" button again

The next group is:

The LCD- display reads the number of pulses of the encoder. Turn the hand wheel

And the number counts up or down, dependent on the direction. The index signal

resets the counter at 2000 (up) or 1 (down). If the encoder counts up and the

number changes at 2000 to 1, every thing is fine.

To go to the next group, press the "ARROW-ROUND" button again

The next group is:

This test allows testing the "balance" of the motor. If this adjustment is not

correct, the motor turns hot while operating.

To perform the test the motor has to be disconnected from the machine.

Push the NU/ND- button, the motor starts running with a low speed (100 rpm) for

about three revolutions. The display reads: "WAITING FOR INDEX"

After the motor stops, the following message will be displayed:

"CALCULATE OFFSET". When the offset is calculated, the result will be

displayed: "ADJUSTMENT: + xx " or "ADJUSTMENT – xx"

"+xx" or "- xx" represents a number. This number should not be higher then 15.

If the reading is not correct, please repeat the test (Press NU/ND again).

5.6 counts is one degree.

--12--

Test Encoder / Index

Test Motor (Balance)