Dodge 11 D Kullanım Kılavuzu - Sayfa 5

Endüstriyel Ekipmanlar Dodge 11 D için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dodge 11 D 8 sayfaları. Flexidyne drive

Sayfayı Yazdır

REPLACEMENT OF PARTS

Disassembly

1. Loosen set screws in collar and remove FLEXIDYNE Drive

from motor shaft.

2. Remove filler plug and drain flow charge from FLEXIDYNE.

3. Remove housing screws and remove housing cover. Remove

cover seal retainer by inserting a small pin in the holes for

the drive screws and tapping on rod to remove drive screws.

Remove cover seal.

4. Remove the four drive hub screws and remove the drive

housing. Remove housing seal.

5. Remove seal felt and seal shield from driven hub. Remove

rotor.

6. Remove collar, outer ball bearing snap ring, and slide driven

hub off drive hub.

7. Remove inner ball bearing snap ring and remove ball bearing.

8. To remove needle bearing from driven hub, place a plug in

the right hand end (as viewed in the drawing) of the driven

hub and press on plug to remove bearing and seal.

Reassembly

1. Press needle bearing into driven hub. Left hand end of

needle bearing should be 5/16 from left hand end of driven

hub for size 11D and 11DL; ¼ from left hand end of driven

hub for size 15D. Bearing should be completely filled with

high temperature roller bearing grease. Tap needle bearing

seal into place, flush with end of driven hub.

2. Press ball bearing onto drive hub, pressing against inner (not

outer) race of ball bearing. Install inner ball bearing snap ring.

3. Slide drive hub into driven hub. Press against bearing not

drive hub. Be careful not to damage needle bearing seal with

any sharp edge on the drive hub during assembly.

4. Install outer ball bearing snap ring, seal shield, seal felt and

motor shaft collar.

5. Place rotor in position on driven hub. Install and tighten rotor

screws.

6. Stand FLEXIDYNE on collar end and place housing seal (red

in color) in position on end of driven hub.

7. Using dowel pins as guides place drive housing in position

and tap gently until housing starts to pass over housing seal.

The seal may tend to cock. A wire or other blunt probe may

be used to push outer corner of seal into position in drive

housing. Rotating the driven hub may also help to position

the seal properly. When seal is properly positioned tap drive

housing into place. Install and tighten the four drive hub

screws.

8. Install cover seal (gray in color) in drive housing cover. Line

up holes in seal retainer with holes in cover and install drive

screws.

9. Place cover in position on drive housing so that filler plugs

are diametrically opposed. Install and tighten housing

screws.

10. Install filler plug. Tighten to recommended torque of 200

inch-pounds for size 11D & 11DL; 700 inch-pounds for size

15D.