Dog Care AB02 Manuel - Sayfa 3
Evcil Hayvan Bakım Ürünü Dog Care AB02 için çevrimiçi göz atın veya pdf Manuel indirin. Dog Care AB02 5 sayfaları. Bark control collar
a. The vibration mode is the default mode when first used. Each time the bark control
collar detects barking based on the sensitivity level you've set, it will beep and vibrate,
and the light will flash blue.
b. If your dog is not sensitive to the vibration and will not stop barking, press the mode
button to switch to electrostatic mode. When the static mode is used the lights flash
red. When the bark control collar detects barking 7 times over 113 decibels in 30
seconds, it will release correction signals with 7 levels.
i. Level 1: beep sound correction.
ii. Level 2: sound and vibration.
iii. Level 3: sound, vibration, and level 1 static.
iv. Level 4: sound, vibration, and level 2 static.
v. Level 5: sound, vibration, and level 3 static.
vi. Level 6: sound, vibration, and level 4 static.
vii. Level 7: sound, vibration, and level 5 static.
c. If your dog does not bark again within 30 seconds, the bark control collar will reset itself
to the lowest level of static correction.
d. Safety feature. If your dog barks over seven times in 30 seconds the collar will go into
standby for one minute.
11. Can I connect this to a controller?
a. No. This collar operates on its own, there is no option to use a controller.
12. Bark collar doesn't respond.
a. Tighten the strap and/or trim dog's hair where the contact points touch their
neck to ensure good skin contact with both prongs.
b. Test the collar to see if it works properly. (See # 9 above).
13. The collar works when my dog is not barking. It beeps/vibrates when my dog moves.
a. The strap may have loosened. When your dog moves the unit may be tapping on his
neck and causing the sensor to activate. Tighten the strap and make sure the prongs
have good contact with their skin.
Safety
1. When using the bark control collar the first few times the dog owner must observe the dog's
response. Be aware that if your dog is very aggressive there is a chance that the static mode