Dog trace d-control 200 mini Kullanıcı Kılavuzu - Sayfa 6
Evcil Hayvan Bakım Ürünü Dog trace d-control 200 mini için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Dog trace d-control 200 mini 20 sayfaları. Electronic training collar – basic training set for one dog. electronic training collar – basic training set for two dogs – with a carrying case
Sayfayı Yazdır
Battery insertion and replacement
INSERTION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER
Unscrew the 4 screws of the top of the receiver using a cross-head screwdriver and remove the lid.
Insert the lithium CR2 3V battery into the battery compartment. Please check that and the battery
is installed with correct polarity (according to the polarity indicated with the "+" symbol in the
battery compartment - see the picture). Wrong polarity may damage the unit.
A beep sound is emitted indicating the correct installation of the battery.
If the beep sound is not emitted after the battery is inserted, remove it immediately. Initialize the
system by using a metal tool (e.g. a screwdriver, scissors, etc.) and short-circuit (connect) both
contacts of the battery holder for about 2 seconds (see the picture on the page 16). Please check
the correct polarity and try to insert the battery again.
Before putting the lid of the receiver back in place, make sure that the rubber seal is correctly
seated in its groove. Screw down the 4 screws of the top tightly (do not over tighten them).
Checking the battery status
LED indicator on the receiver's front cover indicates the status of
the battery:
Green flashing LED indicates the battery is fully charged.
Red and green flashing LEDs together indicate low battery.
Prepare a spare lithium CR2 3V battery and follow the
instructions described in the section "Battery insertion and
replacement".Make sure that the receiver works correctly.
6
Checking the battery status