Dogtra 3500X Kullanıcı El Kitabı - Sayfa 11

Evcil Hayvan Bakım Ürünü Dogtra 3500X için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Dogtra 3500X 19 sayfaları. Expandable to 2-dog system
Ayrıca Dogtra 3500X için: Kod Ayarlama Kılavuzu (2 sayfalar)

Sayfayı Yazdır

Battery Charging Procedure

The 3500X Series uses lithium polymer batteries.

The battery charger and charging cables allow you to

charge both the transmitter and receiver at the same

time. The battery charger is designed for a 120 volt wall

outlet.

Note 1: Only use Dogtra-approved lithium polymer

batteries and chargers for your Dogtra e-collar. This

will prevent any damage that can be incurred from

attempting to use a different charger.

Note 2: The unit has a partial charge when it leaves the

Dogtra facility. Upon receipt of the collar, be sure to give

it a full 2-hour initial charge before the first use. When

a charger is not in use, disconnect it from the power

source.

1. Attach the charging cables to both the transmitter

and receiver, as shown above.

2. Plug the charger into a 120 volt wall outlet or, if using

the auto charger, plug into a cigarette lighter only for

lithium polymer batteries (use a 230 volt European

charger for Europe). All indicator lights should glow

red when properly plugged in and the unit will

automatically shut off during the charging process.

You will need to turn the unit on again before use

once the unit is fully charged and unplugged from the

battery cable.

3. The lithium polymer battery is fully charged within

2 hours. The lights will stay red during the charging

process. The red light will turn green once the unit is

fully charged.

4. After charging, cover the battery charging receptacles

with the rubber plugs on the transmitter and receiver.