Clockaudio CRM 202-RF Kurulum Kılavuzu

Mikrofon Clockaudio CRM 202-RF için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Clockaudio CRM 202-RF 1 sayfaları.

Sayfayı Yazdır

P R O F E S S I O N A L M I C R O P H O N E S Y S T E M S

The CRM 202-RF is a dual boundary layer through table cardioid condenser microphone, with a built-in

mechanism that will allow the user to make the microphone disappear without having to physically

remove it from the table. This is achieved by simply pressing the top of the microphone downwards

until it locks; then by pressing the microphone again it will raise itself back to its original position

above the surface of the table. Engineered in high quality brass with built in shock mount and RF filter.

Fig A

Fig B

Installation guide

1) Drill a 58mm (2.25") hole through the table

see fig A.

2) Remove the nut and fit the CRM 202-RF

through the 58mm (2.25") hole see fig B.

3) Replace nut and tighten to the underside of

the table see fig C.

4) Connections for each mic A + B will be

identified: mic A has white sleeved cable,

mic B has black sleeve and is 180deg from

mic A: Red Phase +, White Phase – and

screen Ground.

Grey 2 core (red and blue wires) is to be

used for remote switching, screen is not

used. Also note switch is open circuit when

the mic is down. Please take note

programming will be needed on the

DSP side to allow the microphone to

be muted once retracted.

5) Ready to go; simply push down on the

centre of the CRM 202-RF to raise the

microphone. Reverse this action to lock

down. See fig D.

www.clockaudio.com



Offering 2 independently wired mics A + B



Fitted with a magnetic reed switch designed

to be used for remote switching at the

beginning and end of each session when the

microphones are no longer in use. The

switch contact is closed (ON) when the

microphone is in the up position and (OFF)

when retracted.



Easy to install



Low profile at surface level



Unique ability to lock capsules away from

sight when not in use



Robust brass construction



Cardioid polar pattern



Built in RF filter



Balanced output



Supplied with 2 x 2m (6.6ft) 2 core +

screen audio cable and 1 x grey 2 core cable

for internal reed switch



Satin Nickel (CRM 202N-RF) or Black Nextel

(CRM 202-RF) finish

CRM 202-RF

Fig C

Fig D