DogWatch I-50 Kullanım Talimatları - Sayfa 2

Güvenlik Sistemi DogWatch I-50 için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. DogWatch I-50 4 sayfaları. Hidden fence systems
Ayrıca DogWatch I-50 için: Ürünler ve Özellikler (10 sayfalar)

Sayfayı Yazdır

IMPORTANT SAFEGUARDS

• The I-50 Series is intended for pet training only. Do not use this prod-

uct for any other purpose.

• Please read the DogWatch Owner's Guide before starting installation

and training.

• Keep the receiver collar and transmitter out of reach of children.

• Never adjust the transmitter while your pet is wearing the receiver collar.

• Unplug the transmitter when the system is left unused for extended

periods.

• This product is for INDOOR USE ONLY.

I-50 SYSTEM SERIES

The I-50 series transmitters are designed to radiate a coded radio sig-

nal allowing you to protect a specific area or to be used with a bound-

ary wire to protect multiple areas. The I-50 and I-50/4 transmitters oper-

ate with DogWatch AM (AR series) receivers. The I-50 FM and I-50

FM/4 SafeLink

transmitters operate with System 3000 receivers (see

chart on front page).

POWER

The solid green loop indicator light on the FM version and the blinking

green light on the AM version lets your know that the transmitter is oper-

ating. Simply plug the power supply into the transmitter jack labeled

"PWR", and set the MODE switch to "INT". (For multiple rooms, see

page 4 - Transmitter with Boundary Wire.)

MODE

The I-50 series transmitter may be used as a stand-alone unit or with a

boundary wire for multiple avoidance areas. The MODE switch allows

you to choose your application. You cannot use both applications at the

same time. INT allows you to use the transmitter as a stand-alone unit.

EXT allows you to use the transmitter with boundary wire.

RANGE

The I-50 series transmitters send a coded radio signal (signal field). You

can adjust the distance that the radio signal extends from the transmit-

ter or the boundary wire. Turn the knob to "+" to increase the range and

"-" to decrease the range. Always test the signal field before allowing

your pet near the avoidance area. Never adjust the transmitter while

your pet is wearing the receiver collar.

TERMINAL CONNECTIONS

When using a boundary wire, strip and connect one end of the bound-

ary wire to the terminal connections. This is the beginning of the wire

boundary system. NOTE: Be sure MODE switch is set for EXT.

- 2 -

ADJUSTING THE COLLAR

Collar tightness is critical. All contact points must touch your dog's skin.

If not, he will not receive a correction stimulation. A loose collar will also

allow the contact posts to rub back and forth on the skin, possibly caus-

ing irritation. Use care as over-tightening the contact posts could cause

damage to the receiver.

The receiver collar should be removed each day to allow your dog's skin

to gradually condition itself to the contact posts. Failure to follow this

procedure could lead to skin irritation and possible infections.

YOUR DOG'S RESPONSE TO STIMULATION

Electrical stimulation has been a safe and effective part of dog behavior

conditioning for over twenty years. All dogs respond differently when

they feel mild electrical stimulation.

Some dogs may demonstrate little, if any, reaction, while others may

yelp and/or jump back. Some dogs "freeze." Do not try to comfort him

after he receives electrical stimulation or you will reinforce his anxiety.

PLEASE REMEMBER

• Adjust the collar and test the battery regularly.

• Keep the contact posts clean.

Diagram 1

Smaller Signal Field

Larger Signal Field

Close End

- 3 -