ASG DTT-L 100 Kullanıcı Kılavuzu - Sayfa 9

Test Ekipmanları ASG DTT-L 100 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ASG DTT-L 100 15 sayfaları. Digital torque testers

Basic Function (Continued)

Zeroing the Tester

While operating the tester, it may be necessary to zero the display so that residual torque does not become part of the measured

reading. Press and release the ZERO key.

You can choose from the following units of measure depending on the capacity of your tester: N.mm (not available on the DTT-L 500),

N.cm, N.m, kgf.cm, kgf.m, lbf.in, and lbf.ft. To change the display units, press the UNIT key. Each time the UNIT key is pressed, it will

select the next available unit until the tester returns to its original setting. The DTT-L automatically converts readings as new units of

measure are selected.

NOTE: All units may not be displayed depending on tester capacity.

You can choose from the following modes of measure: Track, First Peak, and Peak. To change the display mode, press the MODE

key. Each time the MODE key is pressed, it will select the next available mode until the tester returns to its original setting.

ASG, Division of Jergens, Inc.

S. Waterloo Road | Cleveland, OH

15700

DTT-L Series Digital Torque Testers

User Manual

Track Mode

Press the MODE key until "Track" appears on

the display. The display will now indicate the

torque applied in either direction as it is applied

to the transducer.

First Peak Mode

Press the MODE key until "FPeak" appears on

the display. The display will show the torque

level applied to the transducer.

Peak

Mode

Press the MODE key until "Peak" appears on

the display. The display will show the maximum

torque applied to the transducer during a cycle.

| Phone: (

44110-3898

888) 486-6163

| Fax: (

| Email: [email protected] | www.asg-jergens.com

216) 481-4519

Page 9 of 15