Doiting ESP-M2 Kullanıcı Kılavuzu - Sayfa 16

Kablosuz Yönlendirici Doiting ESP-M2 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Doiting ESP-M2 19 sayfaları.

DOITING

11. Peripheral Design Suggestion

Wi-Fi module is already integrated into high-speed GPIO and Peripheral interface, which may be

generated the switch noise. If there is a high request for the power consumption and EMI characteristics,

it is suggested to connect a serial 10~100 ohm resistance, which can suppress overshoot when switching

power supply, and can smooth signal. At the same time, it also can prevent electrostatic discharge (ESD).

The information in this article, including the URL for reference, if there is any change, without prior

notice.

Documents are provided by the current version without any guarantee responsibility, including

merchantability, suitable for any particular purpose or non-infringement guarantees, and any guarantees

presented by any proposal, specification, or sample mentioned elsewhere. This document has no any

responsibility, including the use of the information within this document produced by the infringement of

any patent rights. This document in this, by estoppel or otherwise, grant any intellectual property

licensing, whether express or implied license.

The Wi-Fi alliance marks shall be owned by the Wi-Fi alliance.

All the mentioned brand names, trademarks and registered trademarks presented in this document are

the property of their respective owners, and hereby declare.

FCC regulatory information

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Warning: changes or modifications not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

End Device Labelling

Please notice that if the FCC identification number is not visible when the module is installed inside

another device, then the outside of the device into which the module is installed must also display a label

referring to the enclosed module. This exterior label can use wording such as the following: "Contains

FCC ID: 2A2P9-ESP-M2" any similar wording that expresses the same meaning may be used.

RF Exposure Compliance

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 20cm between the radiator

& your body. This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Installation Notice

The module is limited to OEM installation ONLY. The OEM integrator is responsible for ensuring that

the end-user has no manual instruction to remove or install module.

ESP-M1/M2 User Mannual

Page 13