CYP CSC-220 Kullanım Kılavuzları - Sayfa 5

Medya Dönüştürücü CYP CSC-220 için çevrimiçi göz atın veya pdf Kullanım Kılavuzları indirin. CYP CSC-220 10 sayfaları. Video to pc/hdtv scaler

7. Power and LED button: Press once to power on the unit, press again to turn it off.

Note:

* Under picture adjust mode, press  and simutaneously will revert the selected

parameter back to factory preset value. Press both buttons for over 5 seconds.

will revert all picture parameters back to their factory preset values.

* You can use RS-232 to lockout the front panel controls. To lift this lockout

and revert all parameters back to factory preset value, please press "mode"

and "picture" buttons simultaneously for over 10 seconds.

8. IR Sensor: Infrared remote control sensor.

9. Front Panel Lockout: Under certain circumstances it may be desirable to disable

(5). Connecting the Video inputs

The video scaler can accept a composite video, an S-Video or a YCbCr/YPbPr or PC

input signal for scaling.

Rear Panel

S-VIDEO

1 . S-Video: Use an S-Video cable to connect the S-Video output of the source video

equipment to the connector labled " S-Video" on the back of the Video

Scaler.

S-Video provides improved performance over Composite Video and is

recommended over composite.

2 . Composite Video: Use a Composite video cable to connect the composite video

3 . YCbCr/YPbPr input: Use the component cable to connect the component output of

4 . PC input: Connect the source computer's VGA output signal to the HD 15 connector

labeled "PC IN" on the back of the Video Scaler.

the front panel controls. For example, to prevent

unauthorized or accidental changes to the setting while the

unit is in use.

To disable the front panel controls use RS-232 to set the

front panel lockout to ON position.

INPUT

VIDEO

output of the source equipment to the connector labeled "Video"

on the back of the Video Scaler.

the source video equipment to the connectors labeled

YCbCr/YPbPr on the back of the video scaler.

Pb/Cb

Pr/Cr

PC IN

RS-232

OUTPUT

RGB/YPbPr

DC 12V