Doka 582778000 Orijinal Kullanım Talimatları - Sayfa 3
Endüstriyel Ekipmanlar Doka 582778000 için çevrimiçi göz atın veya pdf Orijinal Kullanım Talimatları indirin. Doka 582778000 6 sayfaları. Shifting carriage tg
Sayfayı YazdırOriginal Operating Instructions Shifting carriage TG
Positioning the Shifting carriage TG
When a load-bearing tower needs to be lifted, two
Shifting carriages TG are required.
Take the load off the load-bearing tower.
Push the Shifting carriages TG up against the end
faces of the load-bearing towers.
Lower the Shifting carriages TG
Unlock both safety bolts (C) by turning them and pull-
ing them out.
The slot-in lifting profile reaches under the bottom
cross-bar (E) of the tower frame.
The slot-in lifting profile reaches under the bottom
cross-bar of the tower frame.
Push both safety bolts (C) back in and turn them to
lock them.
Turn all the swivel casters to point in the direction in
which you want to wheel the load-bearing tower.
Push the feet into the frames and secure them to
prevent them dropping out.
Using both Shifting carriages TG, evenly lower the
load-bearing tower to the desired height.
Travelling the tower without an
Attachable drive unit DF
9260-201-01
Max. gradient of floor 5%.
Travelling the tower with an
Attachable drive unit DF
9260-207-01
a ... max. 50 mm
999260002 - 03/2011
A Shifting carriage TG
B Attachable drive unit DF
C Safety bolt
D Bottom cross-bar (load-bearing tower)
E Slot-in lifting profile
A
A
B
Max. gradient of floor 3%.
When travelling the tower with an Attachable
drive unit DF, both safety bolts must be
pushed in and locked in place.
9260-206-01
Follow the directions in the "Attachable drive
unit DF" Operating Instructions!
Important points to remember when wheel-
ing load-bearing towers:
Only use with Doka Aluxo, Staxo and d2
load-bearing towers.
Ground clearance of the frame feet max.
50 mm.
It is forbidden to use any other mechanical
assistance for the travelling operation!
Exception: Attachable drive unit DF
Max. speed 4 km/h (walking pace)
The floor must be stable, firm and sufficiently
smooth (e.g. concrete).
Max. configuration that can be transported
using two Shifting carriages TG:
Tables with 3 cross-frames per section and a
max. height of 5.0 m.
The conveyance of persons is forbidden - fol-
low the danger notice.
Particular care is needed with:
- Height offsets
- Steps
- Break-throughs
- Strong wind
Either bridge any openings in the floor with
sufficiently strong planking/boards secured
so that they cannot slip away to either side,
or close off openings with sufficiently strong
side railings!
Keep the travel route clean and free of any
obstacles.
It is forbidden for any other persons to stand
in the immediate danger zone (e.g. near the
frame feet).
When hoisting the Shifting carriage TG by
crane, only use the lifting-bracket provided.
For longer breaks between operations, or
when the Shifting carriages TG are perma-
nently parked, they must NOT be carrying a
load-bearing tower.
After wheeling the Shifting carriage TG to its
new position, fix it with its parking brakes so
that it cannot be moved accidentally.
The Formwork Experts
C
D
E
3