Akron OMEGA 3526 Kurulum, İşletim ve Bakım Talimatı - Sayfa 2

Monitör Akron OMEGA 3526 için çevrimiçi göz atın veya pdf Kurulum, İşletim ve Bakım Talimatı indirin. Akron OMEGA 3526 2 sayfaları.

Sayfayı Yazdır

OPERATING INSTRUCTIONS:

The tiller bar and the upper and lower brake knobs are used to control the monitor. To change the horizontal monitor position

toward the "RIGHT" or "LEFT", get a firm grip on the tiller bar handle and turn the lower brake knob counterclockwise until the unit

can be easily rotated. Turn the same knob clockwise to lock the unit in the desired horizontal position. To change the vertical

monitor position upward or downward, get a firm grip on the tiller bar handle and turn the upper brake knob counterclockwise

until the unit can be easily elevated or lowered. Turn the same knob clockwise to lock the unit in the desired elevation position.

CAUTIONS:

Your monitor and nozzle should be inspected prior to and after each use to ensure it is in good operating condition. Periodically,

an unanticipated incident occurs where the unit is misused in a manner that is inconsistent with standard operating practices. A

partial list of potential misuses includes:

• Operating above maximum rated pressure or flow.

• Not d raining and allowing water to freeze in the unit.

• Prolonged exposure to temperatures above 140 degrees F, or below -40 degrees F.

• Operating in a corrosive environment.

• Other misuse that may be unique to your specific environment.

Also, there are many "tell tale" signs that indicate repair is in order, such as:

• A handwheel that is inoperable or difficult to operate.

• Excessive wear.

• Poor discharge performance.

• Water leaks.

If any of the above situations are encountered, the monitor should be taken out of service, repaired and tested by a qualified

technician before placing it back in service.

MAINTENANCE INSTRUCTIONS:

• Periodically lubricate the grease fittings with Lubriplate Low-Temp or equivalent. Inject the lubricant

until it becomes visible from the bleeder holes in the center of the swivel plugs.

• Periodically clean grit and dirt from around exterior moving parts.

• Periodically operate all functions of the monitor through its full travel.

• The brake band lock on the horizontal and vertical travel may require periodic adjustment. To check

the adjustment, rotate the brake knob counterclockwise until it stops. Turning the brake knob

clockwise 1 to 1

shaft as required. Tightening the set screw reduces the travel of the brake shaft.

• Replace the identification tag if it is worn or damaged.

ISO 9001 REGISTERED COMPANY

1 /

turns should lock the monitor. If the monitor does not lock, adjust the set screw opposite the brake

PHONE: 330.264.5678 or 800.228.1161 I FAX: 330.264.2944 or 800.531.7335 I akronbrass.com

WARRANTY AND DISCLAIMER: We warrant Akron Brass products for a period of five (5) years after purchase against defects in materials or workmanship. Akron Brass will repair or replace

product which fails to satisfy this warranty. Repair or replacement shall be at the discretion of Akron Brass. Products must be promptly returned to Akron Brass for warranty service.

We will not be responsible for: wear and tear; any improper installation, use, maintenance or storage; negligence of the owner or user; repair or modification after delivery; damage; failure to

follow our instructions or recommendations; or anything else beyond our control. WE MAKE NO WARRANTIES, EXPRESS OR IMPLIED, OTHER THAN THOSE INCLUDED IN THIS WARRANTY

STATEMENT, AND WE DISCLAIM ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE. Further, we will not be responsible for any consequential,

incidental or indirect damages (including, but not limited to, any loss of profits) from any cause whatsoever. No person has authority to change this warranty.

revised: 6/11