CYP CH-1109RX Kullanım Kılavuzu - Sayfa 9

Genişletici CYP CH-1109RX için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CYP CH-1109RX 16 sayfaları. Hdmi/ip over single cat5e/6 extender
Ayrıca CYP CH-1109RX için: Kullanım Kılavuzu (12 sayfalar)

Sayfayı Yazdır

6.2 Receiver Front and Rear Panels

Front
CAT5e/6 to HDMI with LAN/PoE/IR CH-1109RX
Power
IR 1
IR 2
DC 48V
Extender
Blaster
1
2
3
4
1
Power LED: The LED will illuminate in red when the 48 V DC power
supply is connected to the AC outlet.
DC 48V: Plug the 48 V DC power supply into the unit and connect
2
the adaptor to an AC outlet.
3
IR 1 Extender: Connect to the supplied IR extender cable for IR
signal reception. Ensure that the remote being used is within the
direct line-of-sight of the IR extender.
IR 2 Blaster: Connect to the supplied IR blaster cable for IR signal
4
transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
RS-232 Out: Connect to a PC/Laptop or RS-232 enabled device
5
with a D-Sub 9-pin cable for the transmission of RS-232 commands.
5
Link LED: The Link LED will illuminate in yellow when the both the
Transmitter and Receiver are properly connected and data is
being transmitted/received.
6
HDCP LED: The HDCP LED will illuminate in red when the input
source signal contains HDCP data.
Mode LED: The Mode LED flash green when the device is
7
processing data.
CAT5e/6 In: Connect to the Transmitter unit with a single CAT5e/6
9
cable for the transmission of all data signals.
12
HDMI Out: Connect to an HDMI equipped TV/monitor for display of
the HDMI input source signal.
13
LAN 1/2/3: The LAN connections can be used to connect and
share up to 6 Ethernet connections (3 at the Receiver end, 3 at the
Transmitter end), including computers, routers and media servers.
7
Receiver
CAT5e/6
RS-232
In
Out
HDCP
Link
Mode
5
6
8
9
Rear
LAN 1
HDMI
Out
10
LAN 2
LAN 3
11
4