CYP CH-501RX Kullanım Kılavuzu - Sayfa 10
Genişletici CYP CH-501RX için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CYP CH-501RX 16 sayfaları. Hdmi over single cat5e/6/7 transmitter and receiver
Ayrıca CYP CH-501RX için: Kullanım Kılavuzu (16 sayfalar)
Sayfayı Yazdır
6.2 Reciever Front and Rear Panels
Front
HDMI Out
CAT5e/6 to HDMI with IR CH-501RX
1
1
HDMI Out
Connect to a HDMI equipped TV/monitor for display the HDMI
input source signal.
2
RS-232 Out
Connect to the device that is to be controlled (with D-Sub 9 pin
female cable) by RS-232 commands.
DC 5V
3
This blue LED will illuminate when the 5 V DC power supply is
plugged into the unit and connected the adaptor to an AC outlet.
IR 2 Blaster
4
Connect to the supplied IR blaster cables for IR signal transmission.
Place the IR blaster in direct line of sight of the equipment to be
controlled.
5
IR 1 Extender
Connect with the supplied IR receiver cables for IR signal
reception. Ensure that remote being used is within the direct line-
of-sight of the IR extender.
HDCP LED (Red)
6
This red LED will illuminate when the input source signal contains
HDCP data and when it blink it means the input source signal is
without HDCP data.
7
Link LED (Yellow)
This yellow LED will illuminate when the both CAT5e/6 input and
output signal is connected.
RS 232 Out
Receiver
2
Rear
Power DC 5V
IR 2
Blaster
HDCP
IR 1
Extender
3
4
5
6 7 8
Link
Mode
CAT5e/6 In
9
5