CYP CH-501TX Kullanım Kılavuzu - Sayfa 9
Genişletici CYP CH-501TX için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. CYP CH-501TX 16 sayfaları. Hdmi over single cat5e/6/7 transmitter and receiver
Ayrıca CYP CH-501TX için: Kullanım Kılavuzu (16 sayfalar)
Sayfayı Yazdır
6.2 Receiver Front and Rear Panels
Front
HDMI Out
CAT5e/6 to HDMI with IR CH-501RX
1
HDMI Out: Connect to an HDMI equipped TV/monitor of display
1
the HDMI input source signal.
RS-232 Out: Connect to the device that is to be controlled (via
2
D-sub 9-pin female cable) by RS-232 commands.
Power LED: This LED will illuminate when the receiver is connected
3
to a power supply.
DC 5V: Connect the 5V DC power supply to the transmitter and
4
plug the adaptor into an AC outlet.
IR 2 Blaster: Connect to the supplied IR Blaster cable for IR signal
5
transmission. Place the IR blaster in direct line-of-sight of the
equipment to be controlled.
IR 1 Extender: Connect to the supplied IR Extender cable for IR
6
signal reception. Ensure that remote being used is within the direct
line-of-sight of the IR extender.
7
HDCP LED: This LED will illuminate when the input source signal
contains HDCP data and when it blink it means the input source
signal is without HDCP data.
Link LED: This LED will illuminate when the both CAT5e/6 input and
8
output signals are connected.
Mode LED: This LED will blinking when the unit is processing data.
9
10
CAT5e/6 In: Connect to the transmitter unit with a single CAT5e/6
cable for all data transmission.
RS 232 Out
Receiver
2
Rear
Power DC 5V
IR 2
Blaster
HDCP
IR 1
Extender
3
4
5
6
7
Link
Mode
CAT5e/6 In
8
9
10
4