Ashdown MF 284 Kullanıcı Kılavuzu - Sayfa 3

Müzik Ekipmanları Ashdown MF 284 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Ashdown MF 284 18 sayfaları.

ASHDOWN ENGINEERING - MF 284

TOP PANEL

INPUTS

The MoFo range features a 1/4" jack socket which are to be used to connect the output from your

guitar to the amplifier. Always use a high quality guitar lead to ensure a reliable connection, the

integrity of your signal, and the minimising of noise.

GAIN CONTROL

The Gain control is used to vary the amount of signal passing through the pre amp. With the

control set low you will be able to get clean tones (used in conjunction with the Volume as

described later). Increasing the gain allowed more signal to pass through the preamp, causing the

amplifier to overdrive and distort.

BASS, MIDDLE AND TREBLE

This is the qualisation part of the amplifier, and these controls shape the overall response of the

amplifier. Balancing these controls can provide you with a large range of tonse from which to

work. All the controls are interactive (moving onw will alter the way the others function) and you

should spend some time experimenting to find out what's available.

VOLUME

The master Volume controls the final amount of signal that is fed to the power amp and therefore

the overall volume of the amplifier. The Volume works in conjunction with the Gain controls as

follows. For clean tones the Volume needs to be full up, controlling the overall volume with the

Gain controls. For distortion tones at controllable levels, turn the Volume down and the Gain up.

Varying the Gain will control the amount of distortion and the Master will control the level of sound

MF 284

USER GUIDE

REAR PANEL

LINE LEVEL DI

This XLR socket is used to connect the amplifier to a low impedance, balanced output on a PA

system or recording mixer.

REAR PANEL SOCKETS

On ALL models there is a Mains inlte, this is a IEC connector which must have a Mains Lead

plugged into it, this must be of an approved type and it MUST be the 3 WIRE GROUNDED type.

Mains switch is also situated on the rear, this is used to turn the unit on and off between playing

sessions, (disconnect from the mains supply if you do not intend on using the unit for several

hours or days).

SPEAKER OUTLETS

Speaker Outputs are 1/4" jack connectors either 8 Ohms or 16 Ohms (note that it is imperative

you do not operate the unit without a speaker plugged in!)

USER GUIDE