CYP CH-506RXL Operasyon Ma - Sayfa 9
Genişletici CYP CH-506RXL için çevrimiçi göz atın veya pdf Operasyon Ma indirin. CYP CH-506RXL 16 sayfaları. Hdmi/ir/rs-232 over single cat5e/cat6 extender
Ayrıca CYP CH-506RXL için: Kullanım Kılavuzu (13 sayfalar), Kullanım Kılavuzu (16 sayfalar)
Sayfayı Yazdır
6.2 Receiver Front and Rear Panels
Front
IR1 Extender
RS232 Out
IR2 Blaster
1
2
1
RS232 Out: Connect to the device that is to be controlled (with
the supplied 3.5mm mini-jack to D-sub 9-pin adaptor) by RS-232
commands.
2
IR1 Extender: Connect to the supplied IR extender cable for IR
signal reception. Ensure that the remote being used is within the
direct line-of-sight of the IR extender.
3
IR2 Blaster: Connect to the supplied IR blaster cable for IR signal
transmission. Place the IR blaster in direct line of sight of the
equipment to be controlled.
4
HDMI Out: Connect to a HDMI equipped TV/monitor for display of
the HDMI input source signal.
5
DC 5V: Plug the 5 V DC power supply into the unit and connect the
adaptor to an AC outlet.
6
Link LED: The yellow LED will illuminate when both the input and
output CAT5e/6/7 signals are connected.
7
Power LED: This green LED will illuminate when the device is
connected to a power supply.
8
CAT5e/6 In: Connect to the transmitter unit with a Single CAT5e/6/7
cable for transmission of all data signals.
HDMI Out
3
4
Rear
7
DC 5V
Power
Link
Lite
5
6
CAT 5e /6 In
8
4