Ashford e-Spinner 3 Talimatlar Kılavuzu - Sayfa 2

Dönen Tekerlekler Ashford e-Spinner 3 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Ashford e-Spinner 3 6 sayfaları.
Ayrıca Ashford e-Spinner 3 için: Montaj Kılavuzu (6 sayfalar)

Sayfayı Yazdır

ASSEMBLY INSTRUCTIONS FOR

THE ASHFORD e-Spinner 3

Tools Required

Before commencing, please read these instructions

completely, identify the parts and note the assembly

sequence.

Finish

Your e-Spinner 3 has been lacquered prior to

assembly. If desired Ashford Finishing Wax Polish may

be applied to further enhance its appearance.

(small hammer)

Assembly

1. Squeeze and slide the stainless-steel yarn guides

onto the flyer arms.

Note the nylon eyes are on the same side.

NOTE: when spinning at higher RPM it may be

necessary to squeeze and rotate whichever yarn

guide isn't being used to achieve perfect balance.

2. Cut the nylon brake band into 2 pieces, 35cm (14")

for the brake band and 65cm (25½") for the lazy

kate. Tie the 35cm (14") piece to one of the springs

attached to a screw eye. Then tie the spring to the

brake band allowing approx. 27cm – 28cm (10½ – 11")

between the springs. See illustration. Thread the

tail of the nylon brake band down the inside of the

spring and trim off surplus.

27cm – 28cm (10½" – 11")

Screw eye

3. Rub candle wax onto the end of the

screw eye. Thread the screw eye with the

tension spring and brake band attached,

into the pilot hole in the left-hand side.

4. Rub candle wax onto the end of the

screw eye. Thread the screw eye into the

pilot hole in the right-hand side.