Ashford KIWI 2 SPINNING WHEEL Manuel - Sayfa 10

Dönen Tekerlekler Ashford KIWI 2 SPINNING WHEEL için çevrimiçi göz atın veya pdf Manuel indirin. Ashford KIWI 2 SPINNING WHEEL 13 sayfaları.
Ayrıca Ashford KIWI 2 SPINNING WHEEL için: Talimatlar Kılavuzu (13 sayfalar)

Sayfayı Yazdır
Ashford KIWI 2 SPINNING WHEEL Manuel
Lay the wheel on it's back. (protect your table with a towel or piece of cardboard)
Remove the front conrod from the crank.
Insert the front conrod joint into the right treadle board. Hold the conrod joint with one hand on either
side of the treadle board. With both hands turn the conrod joint a ¼ turn towards you. Slide it up into
the small slot and turn it back a ¼ turn until it clicks into place.
Then repeat this sequence for the rear conrod and the left treadle board.
Finally click the front conrod back onto the crank.
NOTE: It easier to insert the rear conrod joint into the treadle board when the treadle board is at the
lowest point - turn the wheel until the rear conrod is in the lowest position.