Cypress CY3633 Kullanıcı Kılavuzu - Sayfa 8
Mikrodenetleyiciler Cypress CY3633 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cypress CY3633 20 sayfaları. Wirelessusb ls gaming dvk
Sayfayı YazdırWirelessUSB™ LS Gaming DVK User's Guide
The Game Controller has a PSoC™ device labeled "XBOX G" installed into socket U3 of the Plat-
form Board. The Game Controller can be powered with batteries or the provided power supply
connected to J5 (DC power jack).
To configure the XBOX system, perform the following steps:
1. Power on the XBOX game console and load any XBOX game.
2. Install the USB Hub Adapter board as shown in Figure 3 above and ensure that the radio mod-
ule is installed in P1 correctly.
3. Connect the XBOX USB Adapter Cable to any of the four game ports on the XBOX Console.
4. Attach the "A" end of the standard USB cable to the other end of the XBOX USB Adapter
cable.
5. Connect the "B" end of the standard USB cable into Platform Board connector J3.
6. Verify that header J2 has pins 1 and 2 connected, which selects VBUS as the power source
for the board.
7. On the Game Controller board, verify that the radio and the proper PSoC™ adapter board are
installed on the board before power is supplied to the assembly. Verify that all eight potentiom-
eters, POT A-H, are turned fully counterclockwise.
8. If batteries are used as the power source, then install them now or plug in the DC power sup-
ply if batteries are not being used. Only one or the other can be used at a time. Ensure that
header J2 has pins 2 and 3 connected. This selects the battery or external DC power source.
9. Perform the binding procedure described in Section 2.3.
The figure below shows the PSoC Adapter Board that is used to adapt the 48-pin SSOP PSoC to
the 48-DIP socket on the platform board.
Pin 1
Page -4
CY8C27643 48-pin
SSOP PSoC
PSoC Adapter Board
Figure 4. PSoC Adapter Board Assembly
In System
Programming
Header
WirelessUSB™ LS Gaming DVK User's Guide Rev 1.1