Cypress MB9BF567N Kullanıcı Kılavuzu - Sayfa 6

Mikrodenetleyiciler Cypress MB9BF567N için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cypress MB9BF567N 12 sayfaları. Peripheral 32-bit microcontroller

Sayfayı Yazdır
3.4

USB

The peripheral board can detect USB device and read USB content. In sample project the firmware will read folder
name in USB and display the last one on LCD.
Operation steps:
1.
Press SW2 to switch module to USB and press SW3 to enter USB
2.
If there is a USB in USB port, the folder name will display on LCD
Note:
If the USB host is used, the jumper J3 and J4 need to be closed,
If the USB slave is used, the jumper J3 and J4 need to be open.
3.5

EEPROM

There is a 2K EEPROM soldered on peripheral, user can save 2K data in it.
Operation steps:
1.
Press SW2 to switch module to EEPROM and press SW3 to enter
2.
The right and left key can move cursor
3.
The up and down key can change the address, data and read/write mode
4.
The enter key used to enter the write/read operation
3.6

LIN

The LIN module can connect with another LIN board and communication with it.
The sample code of peripheral board execute receiving mode, when data transfer the LCD will display "test OK".
Operation steps:
Connect "12V VCC", "GND" and "LIN" to LIN board
1.
2.
Press SW2 to switch module to LIN and press SW3 to enter
3.
If there is a LIN data send into peripheral board,
4.
The LCD will display
Note:
If the mode is master the jumper J5 need to be connected.
If the mode is slave, the jumper J5 is open
www.cypress.com
SK_FM4_U_Peripheral 32-Bit Microcontroller FM4 Family User Manual
Document No. 002-04464 Rev. *B
5