Acquisitions X-FIRES 600 Kurulum ve Kullanıcı Talimatları - Sayfa 12

Kapalı Şömine Acquisitions X-FIRES 600 için çevrimiçi göz atın veya pdf Kurulum ve Kullanıcı Talimatları indirin. Acquisitions X-FIRES 600 14 sayfaları. Designer flueless fires

Sayfayı Yazdır

Section

1.0

2.0

3.0

4.0

5.0

6.0

7.0

8.0

1.0

IMPORTANT NOTES

The installation and Servicing of this fire MUST only be carried out by a competent person (such as a

GAS SAFE registered fitter) in accordance with the Gas Safety (Installation and Use) Regulations 1998,

the relevant British Standards, Codes of Practice, the Building Regulations and the manufacturer's

instructions.

Failure to comply with the above recommendations could lead to prosecution and invalidate the appli-

ance warranty. This appliance is only suitable for the gas type for which it is supplied.

Always keep a note of the installer's name and address, GAS SAFE registration number, the original pur-

chase receipt and the date of installation for future reference. Failure to produce these documents may

invalidate the warranty.

The appliance must be serviced annually to ensure continued safe operation. See the servicing section

for further reference.

The guard (glass front) is to prevent risk of fire or injury from burns and no part of it should be per-

manently removed. It Does Not Give Full Protection For Young Children Or The Infirm. Parts of

this appliance become naturally hot during use. It is recommended that a suitable fireguard is used,

especially where young children, pets, the elderly or infirm are concerned. The manufacturer of this

appliance considers all surfaces as working surfaces with the exception of the control knob and control

panel.

Combustible items, such as flooring and furniture and soft wall coverings (such as blown vinyl or

embossed paper), low temperature surrounds etc may discolour if fitted too close to the fire. See rel-

evant section for further details on clearances to combustibles. No combustible materials or flooring

should protrude onto the hearth (if fitted).

This appliance incorporates a combustion monitoring system (ODS).

DO NOT burn any foreign material on this fire. Under no circumstances shall the appliance be used if

the glass front door or panel has been removed, damaged or is open. On no account should the appli-

ance inlet or outlet openings be blocked or obstructed in any way

(see figure 1).

DO NOT place any objects on top of the appliance, or cover the

outlet grille in any way. DO NOT operate the appliance with any

parts removed or missing. The integral catalysts should be

checked by the installer upon servicing to ensure there are no

defects or obstructions that may prevent the satisfactory flow of

combustion products.

The expected life of the catalyst is in excess of 11,000 hours (10

years of normal use). After this time the catalyst should be

replaced. This appliance is only suitable for the gas type for which

it is supplied.It should be noted that heaters create warm air cur-

rents. These currents move heat to wall surfaces next to the

heater. Installing the heater next to vinyl or cloth wall coverings

or operating the heater where impurities in the air (such as tobac-

co smoke) exist, may discolour walls.

WARNING: Due to the nature of this product the area around the top of the appliance (i.e. the grille)

gets very hot. Care should be taken when operating the appliance.

U S E R

I N S T R U C T I O N S

Content

Important Notes

Clearances to Combustibles

Ventilation & Room Size

Operating Instructions

Combustion Monitoring System

Cleaning

Servicing

List of Replacement Parts

Outlet openings :

DO NOT BLOCK

Page No

Figure 1

Inlet openings :

DO NOT BLOCK

2012 Acquisitions of London