Cypress EZ-PD CY4533 Manuel - Sayfa 4
Anakart Cypress EZ-PD CY4533 için çevrimiçi göz atın veya pdf Manuel indirin. Cypress EZ-PD CY4533 20 sayfaları. Barrel connector replacement (bcr) evaluation kit
Sayfayı Yazdır
Safety Information
The CY4533 EZ-PD™ Barrel Connector Replacement (BCR) Evaluation Kit (EVK) is intended for use as an evaluation
platform for hardware or software in a laboratory environment. The board is an open-system design, which does not include
a shielded enclosure. Due to this reason, the board may cause interference to other electrical or electronic devices in close
proximity. In such cases, take adequate preventive measures. Also, do not use this board near any medical equipment or RF
devices.
Attaching additional wiring to this product or modifying the product operation from the factory default may affect its
performance and cause interference with other apparatus in the immediate vicinity. If such interference is detected, suitable
mitigating measures must be taken.
General Safety Instructions
ESD Protection
ESD can damage boards and associated components. Cypress recommends that the user perform procedures only at an
ESD workstation. If an ESD workstation is not available, use appropriate ESD protection by wearing an antistatic wrist strap
attached to the chassis ground (any unpainted metal surface) on the board when handling parts.
Handling Boards
The board provided with CY4533 EZ-PD BCR EVK is sensitive to ESD. Hold the board only by the edges. After removing the
board from the box/casing, place it on a grounded, static-free surface. Use a conductive foam pad, if available. Do not slide
the board over any surface.
Do's and Don'ts
CY4533 EZ-PD™ BCR Evaluation Kit Guide, Document Number: 002-25263 Rev. *B
The CY4533 EZ-PD BCR EVK board contains ESD-sensitive devices. Electrostatic charges readily
accumulate on the human body and any equipment, which can cause a discharge without detection.
Permanent damage may occur to devices subjected to high-energy discharges. Proper ESD
precautions are recommended to avoid performance degradation or loss of functionality. Store
unused CY4533 EZ-PD BCR EVK boards in the protective shipping package.
End-of-Life/Product Recycling
The end-of-life cycle for this kit is five years from the date of manufacture mentioned on the back of
the box. Contact the nearest recycler to discard the kit.
Maximum current that can be consumed by an external load connected to the EVK board cannot
exceed 5A.
4