Cypress CM-390 Kullanım Kılavuzu - Sayfa 3

Medya Dönüştürücü Cypress CM-390 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Cypress CM-390 6 sayfaları. Cv/sv/pc/hd/hdmi 1080p scaler box
Ayrıca Cypress CM-390 için: Kullanım Kılavuzu (16 sayfalar)

Sayfayı Yazdır

(4). Operation Controls and Functions

Front Panel

1. Power button and LED indicator:

Press the button once to power on the unit, Press again to power off.

when the unit is powered on, one of the input LEDs will illuminate depending

on your last selection of input source before power off.

The factory default setting for the input is CV (composite video).

The green LED illuminates when composite video is selected.

The Yellow LED illuminates when S-Video is selected.

2. Input select button:

Press the button to select your desired input source between composite

video and S-Video.

3. IR Sensor: Infrad remote control sensor.

4. Menu/Enter: This button serves two purposes.

a. Press the button to enter OSD main control menu as shown in the "OSD Operation".

b. To act as a "enter" key to enter sub menu of your selected item.

5/6. +/- button: Press the button to move up or down the tick V to your

desired parameter. Or after a parameter is selected, Press the button to alter

the value of your selected parameter.

Rear Panel

1. DC power jack: 5V 2A DC power input.

2. Composite Video: Use a Composite video cable to connect the

composite video output of the source equipment to this composite

video(CV) input of the scaler.

3. S-Video: Use a S-Video cable to connect the S-Video output of the

source video equipment to this " S-Video" input on the back of the video Scaler.

S-Video provides improved performance over composite video and is

recommended over composite.

4. PC/HD output: This HD-15 D-Sub connector is shared by PC/RGBHV output

When PC/RGBHV output resolution (VGA to SXGA) is selected,

use the HD-15 to HD-15 VGA cable to connect this output to the PC input

of your display monitor.

When HDTV/YPbPr output (480p, 576p, 720p, 1080i) is selected,

use the HD-15 to YPbPr 3 x RCA cable to connect this output to

the YPbPr input of you HDTV display.

Note: Use of wrong cable for your selected output will result in an abnormal

picture on the screen.

POWER

INPUT

VGA OUTPUT

and HDTV/YPbPr output.

CM-390 Video to PC/HD Scaler Box

INPUT

DC 5V 2A